<th id="5tdxh"><sub id="5tdxh"></sub></th>

<address id="5tdxh"></address>

          <address id="5tdxh"><big id="5tdxh"><delect id="5tdxh"></delect></big></address>

                <thead id="5tdxh"><progress id="5tdxh"></progress></thead>
                  <%=NSW.OConfig.GlobalConfig.SiteName %>
                  歡迎來到耀盾地板輔料官方網站!

                  登錄 | 注冊 | 收藏本站 | 在線留言 | 網站地圖

                  上海耀盾裝飾材料有限公司上海耀盾裝飾材料有限公司

                  分享到:

                  產品供應熱線:400-099-3739

                  熱門關鍵詞:

                  超強抗凍、環保配方
                  當前位置:首頁 » 耀盾資訊中心 » 耀盾百科 » 導(防)靜電地板膠水

                  導(防)靜電地板膠水

                  文章出處:責任編輯:作者:人氣:-發表時間:2014-06-15 字體大小:【

                  應用Application:

                  ²       導靜電地板片材、卷材Conductive floor sheet and coil material

                  ²       防靜電地板片材、卷材Anti-static floor sheet and coil material

                  ²       其它PVC底的導、防靜電地板材Other PVC base conductive and anti-static floor sheet material

                  優點Advantage:

                  ²       導電纖維型,導(防)電效果好,且性能穩定、持久Conductive fiber type, good effect, stability performance and lasting longer

                  ²       水基膠對使用者安全,利于環保 Water-based glue is safe to user and environmental protection

                  ²       粘結力強,干法粘貼,施工方便不易污染地板材 Strong bond strength, dry paste and easy construction. It is hard to contaminate floor.

                  ²       片材、卷材均可使用Apply for sheet and coil material.

                  ²       涂布量大,均為68m2/kg Large amount of glue. Average amount is 6-8 m2/kg.

                  特征Character :

                  ²       灰黑色膠體Gray-black colloidal

                  ²       待膠水干至透明狀方可粘貼地板,敞開時間一般為560分鐘(根據濕度、溫度、吸收情況、上膠量及通風性而異)After glue become transperant, then floor can be pasted. Construction opening time: 5 to 60 minutes. (According to humidity, temperature, absorption and ventilation)

                  ²       用量:每公斤約涂布68m2 Amount : Coating 6-8 m2/kg

                  載體準備Carrier preparation:

                  ²       載體必須堅固、健全、干燥、干凈、平整、光滑、不起砂 The carrier must be strong, dry, clean, level, smooth and free sand.

                  ²       不得使涂層有返潮的危險The coating shall not have the risk of damp.

                  ²       上膠時,基材濕度不得超過3%,須嚴格遵守載體晾干時間 Humidity of base material can’t exceed 3% when coating. Worker must strict compliance with carrier drying time.

                  工作條件 Working condition:

                  ²       溫度:工作地點溫度必須在攝氏18(至少上膠前幾天必須獲得)至45度之間。Temperature in working location should be between 18 to 45 degree (Site temperature should be checked before coating); air humidity: less than 55%HR; ground temperature: less than 10 degree.

                  ²       空氣濕度:應小于55% Humidity is less than 55%

                  ²       地面溫度:不小于10攝氏度 Ground temperature less than 10oC.

                  ²       鋪設前48小時關閉地面暖氣,鋪設48小時后方能重新逐漸啟動暖氣,膠粘劑和材料應提前幾天儲存在工作地點,該處溫度至少要達到攝氏10度以上,這個作法有利于幅面的穩定,并方便于涂層操作。Shut off ground heating system before construction. 48 hrs later after construction, the heating can be turn on gradually. Adhesive and material which is in cutting and vertical laying format will be stored in the construction site several days ago before construction. The site temperature is at least above 10 oC. This can help to keep format stable and easy construct.

                  ²       施工中,潮濕會引起地板表面起泡,影響外觀。During construction, humidity can cause bubble of floor surface. It will impact appearance of ground floor. Pay attention to avoid moisture.

                  上膠Paste Glue :

                  ²       根據地板材的精糙程度和吸收情況選用合適的刮刀,將粘膠均勻地(導電纖維)涂在載體的單面。According to roughness and absorption of floor material to select suitable scraper

                  ²       選用1號刮刀時,每平方涂120克左右Use #1 scraper, 120g/m2

                  ²       選用2號刮刀時,每平方涂160克左右 Use #2 scraper, 160g/m2

                  待候時間Waiting time:

                          本產品屬于含水乳膠,通過組合前水蒸發,以及材料吸收后完成膠合,膠合和晾干的速度取決于粘膠厚度,材料吸收性能、溫度、濕度及現場通風性。本品適合干法粘貼,不可濕貼(特殊場合除外),一般待候時間為5-60分鐘 The product is water-based glue. After water evaporation, material absorption and dry, glue is becoming. Speed of glue and dry depends on thickness of glue, property of material, temperature, humidity and ventilation. The product is suitable for dry paste and not wet paste, except special condition. Normal waiting time is 5 – 60 minutes.

                  工作時間Working time:

                          本品在涂膠后120分鐘左右內粘地板都可(視現場溫度情況而變,一般溫度越高開放時間越長),膠水干后視施工的方便操作即可

                  裱平Level:                            

                  ²       鋪設時,由里面向外逐漸裱平 Level from the inside out

                  ²       利用裱平的把子,探測涂層下面可能出現的鼓起處,并用力將其消除 Use level tools to detect the muster under the coating and eliminate it firmly.

                  ²       20分鐘后,再用重型滾筒(重約60公斤)仔細壓平整個表面(原則上越重越好) 20 minutes later, heavy roller with 60 kg flat whole surface. More heavy more better.

                  ²       裱平必須先橫向進行,隨后再縱向進行 Level must start from lateral direction and then vertical direction.

                  穩定時間Stable time:

                      24小時左右,即可使用。24 hours.

                  最終粘結Final adhesion:

                  ²       鋪設4872小時后,可以用水拖洗或反復使用 Pasting after 48 to 72 hrs, the floor can be washed and cleaned repeatedly.

                  ²       粘貼好后應用清水沖洗粘膠新鮮斑點和鋪設工具 After pasting, fresh spot and tools are flushed by clean water.

                  安全須知 Safety attention:

                  ²       水性膠,非易燃品 Water based glue, non-combustible product.

                  ²       不含溶劑,對使用者無害 Free solvent and none hazardous to user.

                  ²       屬可運輸類 Transportability

                  包裝Package:

                  20公斤塑料桶裝20kg per plastic barrel;10公斤塑料桶裝10kg per plastic barrel;5公斤塑料桶裝 5kg per plastic barrel

                  儲存Storage:

                  ²       在攝氏10度和30度之間,原裝產品可最多保存1 The product can be stored at most for one year between 10 to 30 oC.

                  ²       避免本品結冰 Avoid frozen

                  ²       用后關緊容器蓋子Close barrel tightly after use

                  ²       一次靜止時最多疊放四層 Stacked up to 4 level.

                  簡述Description:

                  1.         基面必須要求結實、平整、光滑、干燥、干凈、不起沙 Base surface should be stiff, flat, smooth, dry, clean and no sand.

                  2.         該產品粘結力很強,使用方便,要求干法粘貼,待膠水呈透明狀時,干透后方可鋪設施工。The product has strong adhesion and easy construction. It is required drying paste. After it become transparent and totally dry, paving work can be done.

                  3.         本產品屬導電纖維型,導電效果很好而且性能穩定,持久The product belongs to conductive fiber type which have good effect, stability performance and lasting longer

                  4.         涂布量大,在正常情況下,涂布量是:6-8平方米/kg.片卷材均可。Large amount of coating at normal condition. Coating amount is: 6-8 m2/kg. Apply to sheet and coil material.

                  5.         建議施工時使用A2或近似A2的自制刮刀,先小面積試用,后大面積使用,刮刀齒深最好控制在1.0-1.6毫米之間。Recommend to use A2 or similar A2 scraper. Firstly, try to paste within small area then large scale use. The teeth height of scraper is between 1.0-1.6 mm. The scraper without teeth is not allowed to use for pasting.

                  6.         實行單面上膠,也可雙面上膠。One either side can also be double-sided adhesive glue.

                   

                   

                   

                  此文關鍵字:pvc地板膠水

                  相關資訊

                  <th id="5tdxh"><sub id="5tdxh"></sub></th>

                  <address id="5tdxh"></address>

                          <address id="5tdxh"><big id="5tdxh"><delect id="5tdxh"></delect></big></address>

                                <thead id="5tdxh"><progress id="5tdxh"></progress></thead>
                                  韩国无码av片午夜福利_亚洲鲁丝片av无码_jk白丝没脱就开始啪啪_翁熄粗大撞击娇嫩小玲